I would like to make a report that shows all the 'disk free' sensors that are either in warning or error. We have a ton of servers here, and a lot of them are showing warnings for disk space. I would very much like to do something about that, but rather than going to each server with a warning to determine if the warning stems from a disk free, it would be much better if I could get a report over it. It's not difficult to get a report over all disk free sensors, but I don't see how I can filter them, so that it only the ones in warning or error that are included?
How do I make a report with specific type of sensors in warning or error?
Modified on 2025-06-10 20:54:35 +0200
Disclaimer:
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.
I believe the easiest way to do this would be with libraries, you can check the manual for more instruction on how to set them up.
Dec, 2017 - Permalink