This article applies as of PRTG 22


Finding the Web Services API (WSAPI) Port for Connecting PRTG HPE 3PAR Sensors to HPE 3PAR System


Where to find the WSAPI port of the HPE 3PAR system that you want to monitor

You must enter the correct WSAPI port for the connection to the HPE 3PAR system in the settings of the parent device or group. You can find the port in the HPE StoreServ settings.


Instructions

Follow the steps below to find the correct WSAPI port:

  • Open the HPE StoreServ Management Console.
  • Select the HPE 3PAR system that you want to monitor from the dropdown menu.
  • Click Overview next to the name of the HPE 3PAR system to open the dropdown menu. Console overview
  • Select Services
    Console dropdown
  • Under section WSAPI Provider, copy the number of the port that is enabled. WSAPI port
  • Open PRTG and navigate to the settings of the parent device or group of the HPE 3PAR sensor that you want to create.
  • Enter the port in the field WSAPI Port and the other required credentials of the HPE 3PAR system in the settings and click Save. WSAPI port
  • You can now create and use the HPE 3PAR sensors to monitor your HPE 3PAR system.


Disclaimer:
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.