This article applies as of PRTG 22



For using Enterprise Virtual Array sensor the manual states that it requires the Command View to be installed on the probe client. Is this necessary?



You do not need to install the Command View on the remote probe. You can instead copy the sssu.exe file from your Command View installation to the probe system.

For PRTG to find this file, you must add an entry to the registry. Open the following registry key:

HKEY_LOCAL_MACHINE\SYSTEM\ControlSet001\Control\Session Manager\Environment

Add a string value called CVEVA_HOME_DIR, and enter the path to the sssu.exe file. Make sure that the path has no backslash at the end.

Make sure that the sssu.exe file that you are using is as of version 10.0.0. Older versions might work too, but there could be problems, in particular if you use spaces in your system or group names.

If you do not know the version of the sssu.exe file, open a command prompt and run the following command:

sssu.exe ?

More


Disclaimer:
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.