This article applies as of PRTG 24
I imported the Cisco MIBs for monitoring client associations on the 5508 controller. However, when adding a sensor in PRTG, only generic SNMP and RFC sensors are available, and none of the Cisco sensors appear. What am I missing?
There's additional information regarding this matter on Cisco's Support Forum. Based on the supplied information, the key OID's for number of connected AP's and Clients are as follows:
| Number of Connected Clients | 1.3.6.1.4.1.9.9.618.1.8.12.0 |
| Number of Connected AP's | 1.3.6.1.4.1.9.9.618.1.8.4.0 |
This can be set-up using our SNMP Custom Sensor, limits can be configured on the "Value" channel after the sensor's creation.
Alternatively, you can import the CISCO-DOT11-ASSOCIATION-MIB and deploy an SNMP Library Sensor. Please refer to the following guide: Can't find a sensor for my device in PRTG but I believe it supports SNMP. How to proceed?
Disclaimer:
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.
