Where did User login timeout go in PRTG 9?
Modified on 2025-06-10 11:27:05 +0200
Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.
Important: We no longer maintain this article. The information might be out of date.
Article Comments
Hello,
this value cannot be set anymore. Sorry.
best regards.
May, 2012 - Permalink
What about within the settings\config\register values? it has to be somewhere.
May, 2012 - Permalink
It cannot be set anywhere anymore. Sorry.
May, 2012 - Permalink
Disclaimer:
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.
Hello,
this value cannot be set anymore. Sorry.
best regards.
May, 2012 - Permalink