I have a server that has multiple drives (3 total) however, 1 drive is used for an application that uses the entire disk (this 0MB Free) and I'd like to do one of the following:
- Adjust multi-disk sensor so that sensor limits do not apply to the one disk/channel in question.
- Remove the one disk from the multi-disk sensor all together.
- Setup a multi-disk sensor that include only the other 2 drives.
how to disable a single drive showing as down in a sensor for multiple drives
Modified on 2025-06-10 11:27:41 +0200
Disclaimer:
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.
Hello,
you can disable the Limits for all drives on the Settings-tab of this sensor. Then go into the Channels-tab, there you can:
best regards.
May, 2012 - Permalink