I have snmp traffic sensors on Brocade CER 2024 MPLS Tunnel Virtual Interfaces but don't see any data. The sensors show green, as connected, but no data.

Article Comments

Hello,

what happens if you disable the "Ignore Zero Values"-Option (under "SNMP Compatibility Options") in the settings of the parent device to these sensors?

best regards.


May, 2012 - Permalink

Made the "Ignore Zero Values" changes and restarted the sensor, still shows zero data. Could it be a MIB issue?


May, 2012 - Permalink

If you then still see 0 values you could scan against the target with our SNMP Tester. Scan twice, with about one minute between the scans and then compare if the counters did change for this very interface.


May, 2012 - Permalink

Ran the SNMP Tester twice, 1 minute apart, counters did not change or start showing data.


May, 2012 - Permalink