Is it possible to display IP next to the device name?

Modified on 2025-06-10 11:29:04 +0200

I would like to display the IP over the device name and not to click the device or roll over to check the IP which are in Alarm state. Please help. Thanks a lot.

Article Comments

Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.

Hello.

to which 'page' or place in PRTG are you actually referring to? The Alarms-Page? Or a alarms-table on a map? Or maybe the Enterprise Console?

best regards.

Apr, 2012 - Permalink

Disclaimer:
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.

Is it possible to display IP next to the device name?

Article CommentsAttention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.

Search

Attention

Related Articles

Article Comments

Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.