Show disk used using Paessler common OIDLIB

Modified on 2025-06-10 11:29:05 +0200

I've got a sensor set up that's monitoring two mount points on a NAS, I used the paessler common OIDLIB and it found the partitions no problem.

What I'd like to do though is set the graph up to show the storage size. Say for instance the vertical axis would be 100TB and then the graph would should storage used out of that 100TB.

I tried looking at the manual scaling but it wants a % value.

Article Comments

Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.

Hello,

you should be able to perform such calculations and display them with the Sensor Factory Sensor.

best regards.

Apr, 2012 - Permalink

Disclaimer:
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.

Show disk used using Paessler common OIDLIB

Article CommentsAttention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.

Search

Attention

Related Articles

Article Comments

Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.