PRTG 9 doesn't appear to recognise the ip sla icmp-jitter test I have running on a Cisco router.

The sensor reports the type as (Not defined) and doesn't run.

This is an example config for this IP SLA test:

ip sla 4 icmp-jitter x.x.x.x tag Test Jitter SLA ip sla schedule 4 life forever start-time now

Article Comments

Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.

Hello,

so are you able to add the sensor, and does it then show an error? If so which? Or does the scan for IPSLAs already fail?

best regards.


Mar, 2012 - Permalink

Yes I can add the sensor OK (the scan for IP SLAs picks up the icmp-latency tests OK) but it fails straight away.

Under the 'settings' tab the 'type' field is set to 'not defined'.


Mar, 2012 - Permalink