Solutions

Telnet to Cisco devices

Modified on 2025-06-10 11:32:20 +0200

Is it possible to telnet out of PRTG to my Cisco devices? That would make perfect sense to me, simply right clicking on the Cisco device and telnet to the monitored device instead of leaving PRTG and starting a DOS telnet.

Article Comments

Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.

Hello,

this is possible by defining 'Telnet' as a new Tool in the Enterprise Console.

best regards.

Mar, 2012 - Permalink

Disclaimer:
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.

Telnet to Cisco devices

Article CommentsAttention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.

Search

Attention

Related Articles

Article Comments

Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.