does SNMP authentication in PRTG support supports UTF-8 character set?

Modified on 2025-06-10 11:33:41 +0200

I wanted to know that the GUI of PRTG for SNMP authenticattion supports UTF-8 wide characters or not? if yes then is those supported for SNMP v1 and SNMP v2c?

Article Comments

Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.

PRTG is using the codepage of the local system and therefore utf8 is not yet supported.

This might change in the near future!

Feb, 2012 - Permalink

Thanks for your quick answer.

Feb, 2012 - Permalink

Disclaimer:
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.

does SNMP authentication in PRTG support supports UTF-8 character set?

Article CommentsAttention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.

Search

Attention

Related Articles

Article Comments

Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.