Solutions

disable default area fill

Modified on 2025-06-10 11:33:47 +0200

hello

all the graphs are filling the primary channel area. (because it is an area) a workaround is to set the primary channel to "downtime" , but this gives an 0% downtime on the preview graphs (in the device view, with all the little graph icons) is it possible to have the primary channel with whatever i want, but as LINE not AREA ?

Article Comments

Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.

Hello,

you can globally switch to "Line Graphs" (i.e. disable Area Graphs) in the Setup->System Administration->System & Website Settings, under Graph Type.

best regards.

Feb, 2012 - Permalink

Disclaimer:
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.

disable default area fill

Article CommentsAttention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.

Search

Attention

Related Articles

Article Comments

Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.