Solutions

Cisco IP SLA sensor for VoIP

Modified on 2025-06-10 11:34:02 +0200

I am using UC500 in my network to provide voice services. Is it possible to get step-by-step procedure for setting up Cisco IP SLA sensor for VoIP? Also, do you have any idea about which commands to set up on UC ?

Article Comments

Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.

Hello,

in PRTG, the steps would be to manually add a Cisco IPSLA Sensor. Of course, to do this at least one IP-SLA has to be set on the target device, I'm afraid we don't have guides how to do that.

best regards.

Feb, 2012 - Permalink

Yes. I have already gone through PRTG manual on how to manually add of Cisco IPSLA sensor. Thank you!!

Feb, 2012 - Permalink

Disclaimer:
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.

Cisco IP SLA sensor for VoIP

Article CommentsAttention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.

Search

Attention

Related Articles

Article Comments

Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.