Hello

What I want to do?

Ich have created some reports an now I want to unselcet/ change some sensors of it. How can I do this?

Best regards

Article Comments

Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.

open the report, select the tab "Select Sensors Manualy" and then delete the unwanted sensors.


Feb, 2012 - Permalink

I found this allready. But there i cant unselect any sensors. Because there I cant see allready seleces sendors. This side dont shows me the selected sensor, it shows me the available once only .


Feb, 2012 - Permalink

which exact version are you running? Please update to latest version.

we had one built that had this issue, but is was fixed since then.


Feb, 2012 - Permalink

Our version is following:

PRTG Version PRTG Network Monitor 9.1.6.1960 Status des Auto-Updates Upgrade auf Version 9.1.6.1960 läuft. (15.12.2011 07:26:00) Betriebssystem Windows 7/2008 R2 (6.1.1 Build 7601 Service Pack 1), 1 CPUs, , on VMware


Feb, 2012 - Permalink

As Aurelio already mentioned, please update to 9.2.0, the issue should then be fixed.


Feb, 2012 - Permalink