How can I monitor a send Connector to my smarthost in Exchange 2007

Modified on 2025-06-10 11:34:41 +0200

We are using Exchange 2007 and are interested in Paessler network monitor. We have a Send Connector to our smarthost configured under hub transport. It is configured to send email to our Barracuda Spam and virus Firewall for outbound processing. I would like to know if there is a sensor to monitor this so that if the send connector stops relaying messages to the Barracuda, I will be alerted. Has anyone seen a sensor like this? can one be created? Sorry I am very new to network monitoring.

Thanks in advance.

solium1

Article Comments

Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.

Hello,

you could use one of the "Email Roundtrip"-Sensors to do this:

best regards.

Feb, 2012 - Permalink

Disclaimer:
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.

How can I monitor a send Connector to my smarthost in Exchange 2007

Article CommentsAttention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.

Search

Attention

Related Articles

Article Comments

Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.