Solutions

PRTG Netflow v9 traffic in and out

Modified on 2025-06-10 11:35:09 +0200

Is it possible with Netflow v9 to show traffic as in/out instead of split traffic to protocols?

Article Comments

Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.

Hello,

it might be easier just to add another SNMP Traffic Sensor monitoring the same interface to get Traffic In/out.

best regards.

Feb, 2012 - Permalink

Okay, I will do that. Thanks!

Feb, 2012 - Permalink

Disclaimer:
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.

PRTG Netflow v9 traffic in and out

Article CommentsAttention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.

Search

Attention

Related Articles

Article Comments

Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.