Hello,
Im after getting the total bandwidth of a switch (cisco 2960 and 3560) in graph to put on the dashboard, is this possible ? If so how?
Thanks
Getting total bandwidth per switch in graph?
Modified on 2025-06-10 11:35:21 +0200
Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.
Disclaimer:
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.
Hello,
you would need to add sensors for all ports on the switch and then add all these up with a Sensor Factory Sensor.
best regards.
Feb, 2012 - Permalink