Hello.

How do I configure SSH authentication? Our PRTG runs on Windows 2008 R2, but we want to monitor a Linux Web server which only allows login from /etc/.ssh/known_hosts. Where do I make or get the required information to authenticate. Until now, there are two entries in /etc/.ssh/known_hosts 11.22.33.44 ssh-rsa VTZUBHTBUHNIJFTUN.... 22.33.44.55 ssh-rsa SAWERJIF....

What do I need to enter there to allow access from the PRTG-Server?

Bye

Article Comments

Hello.

I'm afraid this is not supported by PRTGs SSH-Sensors in the moment.

sorry.


Jan, 2012 - Permalink