Can the memory thresholds of the WMI Windows sensor be adjusted?

Modified on 2025-06-10 11:36:35 +0200

I want to fine-tune when the WMI memory sensor shows a warning state. Is that possible?

Article Comments

Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.

Hi,
please have a look at the sensor's "Channels" Tab.
You can set warning limits seperately for each channel there.
Best regards

Jan, 2012 - Permalink

Disclaimer:
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.

Can the memory thresholds of the WMI Windows sensor be adjusted?

Article CommentsAttention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.

Search

Attention

Related Articles

Article Comments

Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.