I ran the auto update and the core server and the two nodes we have had finished updating (if I run-up the prtg probe admin on the servers it reports the correct versions)

The upgrade was performed yesterday and today I've had to bounce the nodes as I was getting WMI errors on monitored servers that had restarted. After restarting the nodes everything came back to normal. However the update status is still saying "Updating to version 9.1.5.1900.

Article Comments

Dear Conrad,

seeing as version 9.1.6 is already available, can you try updating to this one with the auto-update?

best regards.


Dec, 2011 - Permalink

I've done the update to 9.1.6 but it still displays the following

Updating to version 9.1.6.1963. (12/30/2011 8:40:02 AM) - it is now 10:31

I've checked all the nodes and core server and they are all reporting the new version.

Any other thoughts?


Dec, 2011 - Permalink

that is in the line Latest auto-update message?

if so, this is OK, it is simply the latest mesage from auto update.

You could as well have updated manually, then the latest auto update message wold still show the latest version that was install using the auto update.


Dec, 2011 - Permalink