Hi Support,
i have a few remote probes within the network. How do i control which devices falls under which remote probes during discovery?
thanks Thomas
Adding devices under Remote probes
Modified on 2025-06-10 11:39:05 +0200
Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.
Disclaimer:
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.
Hello
Auto-Discoveries always run under one certain probe (not on several probes). You can of course later on move devices from one probe to another.
best regards.
Nov, 2011 - Permalink