Solutions

Syslog Sensor v9

Modified on 2025-06-10 11:39:30 +0200

I have a number of Syslog sensors which we working as expected prior to upgrading from v8 to v9 (now at v9.1.4.1840). Each sensor was set to a specific sender, which then gave me a log of all messages sent by that particular sender.

Since going to v9, the "Specify Sender" option appears to have no effect, in that the log contains all messages from all syslog sensors.

Is there a fault with this?

Article Comments

Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.

Dear Ian,

unfortunately this seems to be a bug. A fixed version of PRTG should be available next week. Please bear with us.

best regards.

Nov, 2011 - Permalink

Disclaimer:
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.

Syslog Sensor v9

Article CommentsAttention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.

Search

Attention

Related Articles

Article Comments

Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.