Solutions

Simple User interface

Modified on 2025-06-10 11:39:56 +0200

Hello,

I noticed that for every user PRTG gives a lot of functions and allow actions like Add sencors... How can I permit user to check just a few devices and not be able to configure anything else? I need to give to my clients real time traffic data and nothing more.

P.S. I still use PRTG 6 which function very well for this job.

Best Regards Petros Petrouleas

Article Comments

Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.

hallo,

create read only users in PRTG 9.

https://www.paessler.com/manuals/prtg9/user_access_rights.htm

Nov, 2011 - Permalink

Disclaimer:
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.

Simple User interface

Article CommentsAttention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.

Search

Attention

Related Articles

Article Comments

Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.