How can I define a Factory Sensor for multi-processor servers

Modified on 2025-06-10 11:40:09 +0200

Hello,

I would like to configure a Factory Sensor that shows us an error or warnig if the average of the usage of one or more processors are more than 50 per cent for more than xx minutes. But not before. Is this possible? If yes, how must the Factory Sensor be configured?

regards Mikewi

Article Comments

Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.

Error states never have a latency.

You could create a factory that calculates the maximum of the processor usage of multiple processors and then add a notification with a latency if the value is above a limit for a certain time.

Nov, 2011 - Permalink

Disclaimer:
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.

How can I define a Factory Sensor for multi-processor servers

Article CommentsAttention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.

Search

Attention

Related Articles

Article Comments

Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.