How can i change historical data of sensor?

Modified on 2025-06-10 11:40:42 +0200

Hello, we need to change historical data of one SNMP traffic sensor and we need to know how to do that. We need to multiply all historical data of this sensor by two and than we need to see this changed historical data in graph as if they were original.

Can you help us?

Thanks, Lubomir GiTy, a.s.

Article Comments

Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.

I'm afraid that's not possible. Sorry.

Nov, 2011 - Permalink

Disclaimer:
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.

How can i change historical data of sensor?

Article CommentsAttention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.

Search

Attention

Related Articles

Article Comments

Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.