Solutions

How to configure sensor channel ?

Modified on 2025-06-10 11:40:48 +0200

I try to configure the sensors to show information different from basic configuration PRTG.

For exemple

I would to see on graphic sensor the Space used on my disk and not space free ? I would to see on graphic sensor the processeurs used and not processeur avaiblable ?

Thansk for your help...I know it is possible on CACTI :-)..I Imagine it will be the same thing on PRTG

Emmanuel

Article Comments

Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.

You could use a Sensor Factory sensor and substract the result value from the maximum value.

It also depends on the sensor type being used. Often, with SNMP, if there is a disk free OID there might also be a disk used counter.

Nov, 2011 - Permalink

Disclaimer:
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.

How to configure sensor channel ?

Article CommentsAttention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.

Search

Attention

Related Articles

Article Comments

Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.