Solutions

IPv6 Web GUI

Modified on 2025-06-10 11:41:24 +0200

I know that PRTG v9 supports sensors over IPv6 but does the web GUI support ipv6?

As far as I can see in the server administrator app, the only IP addresses listed are v4 ones.

Article Comments

Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.

The PRTG web server as well as the internal connections between PRTG components (cluster nodes, remote probes) currently support IPv4 only.

However, you can connect to your devices and monitor via IPv6 with many of the available sensor types.

Oct, 2011 - Permalink

Disclaimer:
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.

IPv6 Web GUI

Article CommentsAttention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.

Search

Attention

Related Articles

Article Comments

Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.