Within PRTG 9 Web interface I added an IP to allowed under probe connection settings but could not get it to work until I discovered more settings within the Server Administration Tool under the Core Server Tab which had to be set to accept connections from remote probes on all IPs as the 3rd option only had the core servers IP as a tick box. It appears to me the settings within the Web Interface and Admin Tool are slightly conflicting?
Probe connection management
Modified on 2025-06-10 11:41:43 +0200
Disclaimer:
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.
Hello,
they do "touch" the same "topic" but the settings or their intention is very different. In the Server Admin it's about the Core Server and on which own IP it will listen for Probe Connections. In the webinterface the "Probe-IP-List" is about to have the option of specifically closing out certain IP (Probe IPs) to connect to the server, or only allow certain IPs.
best regards.
Oct, 2011 - Permalink