Is is possible to have sensor channel settings inherit? I.e i want all my snmp traffic monitor sensor channels to plot on a 0-100 mbits vertical axis, rather than be dynamic. Is there a way of setting that at device level and have that propagate down?

Article Comments

Hello,

you could try using the Multi-Edit on Channel Settings of your SNMP Traffic Sensors (this requires PRTG 9).

best regards.


Oct, 2011 - Permalink

Hi,

I've done that, but was wondering if there's one place i could set it and have all the traffic sensors inherit the setting. Otherwise i have to manually change it for each sensor.


Oct, 2011 - Permalink

There is no global setting, but with the Multi-Edit on Channels (in PRTG 9) you can do this on multiple sensors at once!


Oct, 2011 - Permalink

Ahhh.. got ya. That will do! Thanks very much!!!


Oct, 2011 - Permalink