I am running PRTG 7 and used the MIB V2.1.1 for PRTG 7 to import CISCO-ISDN-MIB.my. I saved my library as CISCO-ISDN.oidlib in C:\Program Files (x86)\PRTG Network Monitor\snmplibs. But when I go to add the sensor, the new SNMP library does not show up. What step am I missing?
Imported MIB but SNMP library does not show up when adding sensor
Modified on 2025-06-10 11:43:02 +0200
Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.
Disclaimer:
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.
please try restarting the PRTG services and then check again.
Sep, 2011 - Permalink