Is there a way that Paessler can report what device is plugged into a switch port? I would like to map out the network with what is plugged into what switch port and it would be helpful if there was something I could run to assist.
Port Identification -
Modified on 2025-06-10 11:44:48 +0200
Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.
Disclaimer:
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.
Hello,
I'm afraid PRTG can't do this. Sorry.
best regards.
Sep, 2011 - Permalink