I have PRTG 8.4 and would like to know how to add just the sensor on the map, without any design. Only the name and status of the sensor. Whenever I try to add the status, comes with an image of a computer together. Can you help me?
Thank you.
How can I add sensor information to a map in PRTG Map Designer
Modified on 2025-06-10 11:46:21 +0200
Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.
Disclaimer:
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.
Dear Daniel,
you can just select "Name & Status" from the status icons section and drag that again into the designer. Maybe drag it onto the already created Computer Icon.
best regards.
Jun, 2011 - Permalink