i have discover 100 devices and would like to add another custom sensor to all of them. Is there a way to mass add?
thanks
Adding sensor to mutiple device
Modified on 2025-06-10 11:47:13 +0200
Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.
Disclaimer:
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.
Hello,
the recommended way would be to create the sensor once on a device in PRTG, then create a device template from this, edit it with notepad.exe for example to remove all other sensors except the new custom sensor, and then run an Auto-Discovery with the new template on all other devices (that shall have the new sensor as well).
best regards.
Aug, 2011 - Permalink