Hello, I have a device with an interface through which a 3500Mbit / s of inbound traffic. Upon reaching the value of a 3500Mbit / s, PRTG 8.4.2.2381 begins to show no valid data, namely the relatively low values ??of real data.
Options:
SNMP - B2
Overflow values ??- Retry (recommended)
Zero values ??- Ignore zero values ??for delta sensors (recommended)
32-bit/64-bit counters - Use 64-bit counters if available (recommended)
The device - CIsco 7609s
SNMP problem on interface with the traffic of more than 3,500Mbit/s(IN)
Modified on 2025-06-10 11:47:32 +0200
Disclaimer:
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.
Dear Andrey,
just to check it's SNMP v2c? Was the sensor added with SNMP v2c set? (You can quickly add a new one, just to test, if it shows the same numbers as the old sensor).
best regards.
Jul, 2011 - Permalink