I'm using a HTTP sensor with Authentication to monitor a Sharepoint page. I configure it with a username/password that works when I go to the page manually. When I start the sensor, I receive a HTTP/1.1 401 Unauthorized message. Is there another way of doing this? Is this supported with PRTG?
How to monitor SharePoint?
Modified on 2025-06-10 11:47:46 +0200
Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.
Disclaimer:
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.
Hi, I have also some sharepoint-site-sensors. It must be "Einfache Zugriffsauthentisierung (HTTP)" and not NTLM.
Jul, 2011 - Permalink