Solutions

PRTG Network Monitor Probs issue

Modified on 2025-06-10 11:49:13 +0200

Hello , we have implemented PRTG Network Monitor V8 Cluster , the issue is the prob in the Fail-over node says No probes are connected , ans when the fail-over node become the master there is no data are collected .

please advise

Article Comments

Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.

Hello,

can you please send us some screenshots showing the issue to support@paessler.com?

best regards.

Jul, 2011 - Permalink

Disclaimer:
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.

PRTG Network Monitor Probs issue

Article CommentsAttention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.

Search

Attention

Related Articles

Article Comments

Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.