Solutions

I am not getting data for QOS

Modified on 2025-06-10 11:49:28 +0200

I added a Remote device on PRTG through Probe and added a sensor on Probe added but I am not getting and data...

Just for test I added Remote IP of ny PRTG on Probe device for QoS, but still not getting data. Please help..

MOK

Article Comments

Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.

Hello,

first of all, please check if there might be any firewall or similar blocking the packets. Then it might be good if you could forward us some screenshots to support@paessler.com showing the settings of the QoS-Sensor.

best regards.

Jun, 2011 - Permalink

Disclaimer:
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.

I am not getting data for QOS

Article CommentsAttention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.

Search

Attention

Related Articles

Article Comments

Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.