Température conversion of Netgear RNDX NAS
Modified on 2025-06-10 11:49:31 +0200
Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.
Important: We no longer maintain this article. The information might be out of date.
Hy !
I have a Netgear RNDX NAS and in its web interface config i put temperature unit on celcius degres.
But if i use the Netgear MIB (convert with Mib importer) the résult in PRTG is in fahrenheit degres.
I try to use multiplication/division in sensor parameters and i put this value " -32*(5/9) "
but i'm not sure it's correct ?!
Please help me
Article Comments
Hello,
I'm afraid only multiplication/division is possible. For this calculation (Fahrenheit -> Celsius) you would need to use the Sensor Factory.
best regards.
Jun, 2011 - Permalink
Disclaimer:
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.
Hello,
I'm afraid only multiplication/division is possible. For this calculation (Fahrenheit -> Celsius) you would need to use the Sensor Factory.
best regards.
Jun, 2011 - Permalink