Blank device template with Cisco ASR1000 series routers.

Modified on 2025-06-10 11:49:46 +0200

I cannot match any device template to Cisco ASR1000 series router after auto-discovery. Is there anyoue out there experiencing the same problem. Have you solved it? Please shared if you have a solution to this issue.

Thanks!

Leon

Article Comments

Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.

Hello,

do you want to create a new template from a device (representing your Cisco ASR1000)? Or do you want to apply an already existing template to create sensors on a device (representing your Cisco ASR1000)?

best regards

Jun, 2011 - Permalink

Disclaimer:
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.

Blank device template with Cisco ASR1000 series routers.

Article CommentsAttention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.

Search

Attention

Related Articles

Article Comments

Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.