Traphic combined physical interface Cisco switch ?

Modified on 2025-06-10 11:50:18 +0200

Hi,

I am testing PRTG for our environment, and i have a question:

Our Cisco switches have multiple physical interfaces combined, with channel groups on dot1q. ( or IEEE 802.1Q ). So 2 or more gigabit uplinks ( seen as 1 ) are connected to the core switches.

But using SNMP in PRTG i can only see the physical connections. I can't find an option to combine the connections.

Is there a way to see just 1 traphic graph ?

Article Comments

Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.

You could combine the results of the sensors in case using a Sensor Factory sensor

Jun, 2011 - Permalink

Disclaimer:
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.

Traphic combined physical interface Cisco switch ?

Article CommentsAttention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.

Search

Attention

Related Articles

Article Comments

Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.