How to get accurate bandwidth readings without V2 support?

Modified on 2025-06-10 11:50:58 +0200

We are attempting to determine router interface bandwidth, but PRTG seems to be unable to do this for large (over 800 mbps) bandwidth ports accurately. Perhaps this is due to PRTG only supporting V1 / 32 bit counter. We have reset the scan time down to 5 seconds in order to solve, no luck What else can be done?

Article Comments

Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.

PRTG V7/8 support SNMP V1, V2c and V3. You can find this setting in the parent device's settings.

Jun, 2011 - Permalink

Disclaimer:
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.

How to get accurate bandwidth readings without V2 support?

Article CommentsAttention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.

Search

Attention

Related Articles

Article Comments

Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.