Solutions

Setting Toplist interval start times

Modified on 2025-06-10 11:51:14 +0200

I have gone to my Packet Sniffer sensor and changed the Toplist interval time to 1440 (24 hours) but it seems to start at 6PM, when I would much rather it start at 6AM but I can't seem to influence it to change. I've tried adding a new sensor and still when I alter the toplist interval it still goes to 6PM.

Article Comments

Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.

Hello,

it's not possible to set the starting time of a toplist period, except to (re-)start the PRTG Probe service at that time. Please also be aware we strongly recommend not to setup toplist periods longer than 60 minutes.

best regards.

Jun, 2011 - Permalink

Disclaimer:
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.

Setting Toplist interval start times

Article CommentsAttention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.

Search

Attention

Related Articles

Article Comments

Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.