Solutions

interface channels

Modified on 2025-06-10 11:52:50 +0200

I'm using SNMP Traffic Sensor to monitor one of my interface in a switch. I have enable to capture all available channels for this sensor. I noticed that some of the channels like Unicast Out (volume), Unicast out (speed) are all display in # and #/s. Can you explain what the unit means?

Is there any means to change to out units such as bytes or bytes/s ?

thanks

Article Comments

Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.

Hello.

'#' means number of unicast packets in that case. We only get the number of those from the device so any conversion is unlikely.

best regards.

May, 2011 - Permalink

Disclaimer:
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.

interface channels

Article CommentsAttention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.

Search

Attention

Related Articles

Article Comments

Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.