I have an issue with my T1 point to point and slow traffic. I have a Rici T1 Ethernet converter at each end. while looking at the data over a period of time I see that the in on the T1 side aand the out on side b are not even close to equal. over a typical period the data out is 19 kbit/s and 201,800 kbytes total in data is 179 kbit/s and 1,866,000 kbytes total.
Should the "traffic in" on one side of a point-to-point T1 equal the "traffic out" on the other?
Modified on 2025-06-10 11:53:06 +0200
Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.
Disclaimer:
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.
Dear Jim,
if the sensors really monitor the two endpoints of one connection the traffic should be very similar, if of course the sensors have the same settings.
best regards.
May, 2011 - Permalink