Solutions

Get SNMP values to return OK status

Modified on 2025-06-10 11:53:12 +0200

I have an SNMP OID (1.3.6.1.4.1.674.10892.1.200.10.1.2.1) that returns an integer (1-6).

The values are: 1: Other 2: Unknown 3: OK 4: Non-critical 5: Critical 6: Non-recoverable

I would prefer to not set limits on the sensor, but have it return the OK, Warning, & Error status in the sensor. How can I do this?

Article Comments

Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.

Dear Benjamin,

in the moment, you can only use limits for cases like this one. But we are working on a solution for this. Please bear with us.

best regards.

May, 2011 - Permalink

Disclaimer:
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.

Get SNMP values to return OK status

Article CommentsAttention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.

Search

Attention

Related Articles

Article Comments

Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.