Solutions

HTTP Full Page

Modified on 2025-06-10 11:53:32 +0200

I am creating alot of HTTP Full Page sensors and when I am viewing my home page, the URL's are not fully visible. How can I adjust the view settings so that I don't need to click on each sensor to view the full URL?

Thanks, Jon DeSalvatore

Article Comments

Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.

Dear Jon,

which page would be your 'home page' in PRTG? The sensor list?

best regards.

May, 2011 - Permalink

I set my home page from Devices--Group View--Local Probe

May, 2011 - Permalink

I just switched the view from Medium to X-Large and now it shows the full URL's. I guess that works. :)

Thanks

May, 2011 - Permalink

Disclaimer:
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.

HTTP Full Page

Article CommentsAttention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.

Search

Attention

Related Articles

Article Comments

Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.