Can I use hrPING with PRTG?
Modified on 2025-06-10 11:53:53 +0200
Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.
Important: We no longer maintain this article. The information might be out of date.
Hi Paessler,
I have a requiement that needs me to check latency numbers that are less than 1ms.
There is a freeware replacement for PING called hrPING by cFos Software GmbH -- http://www.cfos.de
Is there a way that I can get PRTG to use hrPING rather than PING to allow me to measure latencey down to a microsecond?
Thank You
Peter Venardos
Article Comments
Dear Peter,
you could try using the hrping.exe as a custom exe sensor in PRTG.
best regards.
May, 2011 - Permalink
Disclaimer:
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.
Dear Peter,
you could try using the hrping.exe as a custom exe sensor in PRTG.
best regards.
May, 2011 - Permalink