Solutions

Monitoring SQL and MS Cluster

Modified on 2025-06-10 11:54:05 +0200

I have SQL Cluster with an IP of 10.160.16.61 and a SQL virtual name with IP 10.16.16.64. I would like to monitor both of those. How do i do that in PRTG?

Article Comments

Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.

Hello,

you could add both as devices and then add SQL Sensors to each of them. On the virtual name then the sensors should not fail of course at all.

best regards.

May, 2011 - Permalink

Disclaimer:
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.

Monitoring SQL and MS Cluster

Article CommentsAttention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.

Search

Attention

Related Articles

Article Comments

Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.