How can I change the value in snmp memory report

Modified on 2025-06-10 11:55:30 +0200

I have made a report for cisco switches, using th following snmp sensors: Cpu Load and Free I/O Memory. How can I change the view in the memory sensor, to show percentile used memory, instead of kb free memory. The cpu load is ok showing percent of cpu load.

Or is it possible to make a sensor for snmp memory, like the sensor, Available memory used for servers using WMI.

Where is the html file located in the programfiles, that contains the settings for the I/O memorysensor?

Article Comments

Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.

Hello,

you would need to use the sensor factory to calculate the free percentage of the memory: https://www.paessler.com/manuals/prtg8/sensor_factory_sensor.htm

best regards.

Apr, 2011 - Permalink

Disclaimer:
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.

How can I change the value in snmp memory report

Article CommentsAttention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.

Search

Attention

Related Articles

Article Comments

Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.